|
||||
|
||||
![]() |
1. Cut ribbon to the desired length of the
finished bow. Form into two equal loops.
Hint: Double-faced ribbon works the best. Wire-edge ribbon is also great for this bow. |
|||
| 2. Cross the right loop over the left loop. | ![]() |
|||
![]() |
3. Knot the loops by pushing the right loop beneath the left, then pull the loop under and through the hole. | |||
| 4. Pull the knot tight and adjust the loops and tails until they are the same size. Use scissors to trim the ends of ribbon. Attach the bow to the package with double-sided tape. | ![]() |
|||
|
|
||||
| ©2009 The Container Store® Inc. All rights reserved. |
|
|
ABOUT SSL CERTIFICATES |
| Ref #89998183017 |
version: 1.6.0 build: RC-5 timestamp: Tue Nov 03 12:00:20 CST 2009 worker: worker18